Power switches from Intertechno can be controlled with the IRControl System. Because Intertechno devices works with radio transmission, you need the LAN bridge (ITGW-433), wich you have to connect on your LAN (network cable). You have to register the ITGW-433 as a device in the IRControl system.
You have to enter the Mac address or IP addres and port number of your ITGW-433 device. The configuration of network devices is described in chapter Network Configuration more in details. The configuration item also needs a name and unique id.
With version 10 of Android and later or with an iOS devices, the Mac address of the Intertechno ITGW-433 cannot be determined and the device can therefore only be clearly identified via the IP (if statically assigned). However, this is only necessary if several devices are operated in the network simultaneously. In this case you have the following 2 options: Either you define a static IP for each gateway on your router, or you operate all gateways together as a virtual device. In this case the commands are sent to all gateways at the same time. You shuld consider that you have to configure different control settings for each of the end devices (power switches).
Target
Add for each Radio Control Receiver (Power Switch) a target linked to to ITGW-433 Device.
Select the model type of the power switch. There a 2 different device types. The first one has dip switches or small rotary switch whitch defines the channel code for accessing. The second one you can will be controlled with a 24 bit ID, whitch you have to configure on power device with a learning mode. If your device type is not listet in the dropdown list, take an other one, that is configurable in the same way.
Devices with 24 bit ID you register as follows:
While selecting the device type, the IRConcol System shows a random generated 24 bit ID. You can use it or take an other 24 bit value. It represents the control channel to access the power switch. The commands will be generated automatically for the device. For device types with 24 bit ID, 3 commands will be created: a ON commmand, a OFF command and a reset command.
To configure the device youd have to press the learn button on the device and send ON command. For clear the 24 bit ID on your power device you operate similar with the OFF command. With the reset commmand the power switch is reseted and all learned IDs will be cleared.
Commands can be sent on the tab «Commands» by pressing the 
Button.
